Myler Eggbutt with Hooks MB06

MB06 Eggbutt w/ Hooks



 Independent Side Movement
 

The MB 06 is a Myler alternative to the traditional mullen, but it has a wide low port that allows the tongue to pass under it comfortably. The port is ¾" high, just enough to allow the horse’s tongue to elevate slightly and swallow, but not high enough for palate pressure. When the reins are engaged, the 06 applies pressure primarily to the bars and lips.

• Independent Side Movement
• Stainless Steel Mouthpiece
• Curved mouthpiece does not pinch lips and bars
• Copper Inlay
• NOT Dressage Legal

Notes: This mouthpiece is a step up in tongue relief from Level 2, but because the port is low, it does not offer as much tongue relief as other Level 2-3 mouthpieces with slightly higher ports because the tongue is still somewhat restricted. The MB 36 mouthpiece will offer more tongue relief than the MB 06 when the reins are relaxed, but more tongue pressure when the reins are engaged. For more overall tongue relief, see MB 43LP.

The addition of the hooks to the cheek make this a more versatile version of the eggbutt without hooks. Attaching the headstall to the top hook holds the bit in the correct position instead of allowing it to slide around the bridle cheeks. Attaching the reins to the rein hooks allows the rider to lift the cheek and use the Independent Side Movement™ of the mouthpiece (if available). Using the hooks does not add leverage but allows the rider to transition from a direct rein action to indirect action without changing the bit. Adding a curb strap (using a Myler curb strap kit) incorporates curb pressure. Curb pressure is recommended for ported mouthpieces.

The small loop behind the top slot accommodates a curb strap (attach with two curb hooks). Both the top bridle slot and bottom rein slot will fit standard ⅝" bridle leather.

Size: 3 ½" rounded ring

Action: Direct rein action when rein hook is not used. Indirect rein action when rein is fixed on rein hook.

Discipline: English or Western

Degree of Leverage: Little to no leverage when the hooks are used.

"Designed with the Equine in Mind” - Established 1987 

Ron, Dale and Bob Myler started designing bits over 20 years ago. They developed their approach to bitting from riding their own horses, helping other riders with their horses, working with equine dentists and chiropractors and studying how the bit works in the horse’s mouth. They continue to make custom bits at their shop in Marshfield, MO, in addition to working with Toklat Originals, the exclusive worldwide distributor of Myler Bits.