Myler Kimberwick MB 36 w/ Curb Chain - 12,7 cm

MB36 Kimberwick w/ Curb chain



 Independent Side Movement
 

The MB 36 is a Myler alternative to the traditional mullen, but it has a wide low port that allows the tongue to pass under it comfortably. The port is 1" high, and tilted forward at a 45º angle, allowing just enough room for the horse’s tongue to elevate slightly and swallow, but not high enough for palate pressure. When the reins are engaged, the MB 36 applies pressure primarily to the bars and lip, but also applies tongue pressure because of the forward tilt.

• Independent Side Movement
• Stainless Steel mouthpiece
• Curved mouthpiece does not pinch lips or bars
• Copper Inlay

Notes: This mouthpiece is a step up in tongue relief from Level 2, but because the port is low, it does not offer as much tongue relief as other Level 2-3 mouthpieces with slightly higher ports because the tongue is still somewhat restricted. The MB 36 mouthpiece is similar to the MB 06, except that it is ¼" higher and the port is tilted forward. The MB 06 mouthpiece will apply less tongue pressure than the MB 36 but additionally offer less tongue relief when the reins are relaxed. For more overall tongue relief and less tongue pressure, see the 43LP.

The Kimberwick is a “D” shaped stainless steel ring with a purchase for the headstall and two attachment options for a single pair of reins: the direct (snaffle) and the indirect (curb) positions. Comes with curb chain. Like the Pelham, the purchase creates a fixed cheek so the bit is held in the correct position. The rider can choose the direct (snaffle) position or indirect (Curb) position for rein attachment. The Indirect Rein position adds very little to mild leverage. Designed to be used with only one pair of reins.

Action: Snaffle position is Direct rein action. Curb position is Indirect rein action.

Size: 4" “D” shaped ring with purchase

Discipline: English

Degree of Leverage: Very little to mild leverage when the lower rein hook is used.

“Designed with the Equine in Mind” - Established 1987 

Ron, Dale and Bob Myler started designing bits over 20 years ago. They developed their approach to bitting from riding their own horses, helping other riders with their horses, working with equine dentists and chiropractors and studying how the bit works in the horse’s mouth. They continue to make custom bits at their shop in Marshfield, MO, in addition to working with Toklat Originals, the exclusive worldwide distributor of Myler Bits.